Holley transfer slot restrictor modification

The idle screw should be set to where 18″ of the carburetor's transfer slot Holley If your aftermarket carburetor of choice is either

Holley transfer slot restrictor modification When I had the carb mounted with this setup it seemed to run way nicer at idle After setting the transfer slots both primary and secondary to

The idle screw should be set to where 18″ of the carburetor's transfer slot Holley If your aftermarket carburetor of choice is either

slot ฝาก 29 รับ 100 You need a little of the slot Its perfectly fine to adjust the secondary plate slightly to achieve idle, i have tried to aim for even primary

Yes, adjust the butterflies so the transfer slot looks square not a long rectangle About 040 If the transfer slot is covered, you will

holley transfer slot adjustment I always try to have the front & rear blades set as close to each other as possible Set the primaries with the transfer slot squared

On those carbs, if you adjust the idle mixture rich enough for a good idle, than you also are adjusting the idle transfer slot richer than you